Installation checklists
Contents of this chapter
This chapter contains a checklist for checking the mechanical and electrical installation of
the FSPS-21 module and refers to common cause failure checklists in standards.
Checklists
Check the mechanical and electrical installation of the module before start-up. Go through
the checklists below together with another person and make a memo as needed. Read
chapter Safety instructions (page 13) before you work on the safety system.
￭ General checklist
Check that …
The ambient operating conditions are within the allowed range.
Transportation stops and packing material have been removed from the installation area.
The module is fastened properly.
The drive and the module are properly grounded to the same potential.
The network cable is properly connected.
The STO cable is correctly installed.
￭ Common cause failure (CCF) checklists
Check measures against common cause failures (CCF). There is one checklist in EN ISO
13849-1 and another in EN/IEC 62061. The checklists are useful for both the planning of
the installation and the actual installation.
10
Installation checklists 41
To Next Page
Loading...
