ABB IP Touch 7 - Sound for Notice; Signal Tone for Error; Default Setting for Signal Tone Volume [%]

Control elements and application parameter
Application "Fault and alarm messages" - Global settings
Product manual 2CKA001473B5023
│
118
2.15.6 Sound for Notice
Options: Setting option from 1 - 5
The parameter is used to specify which signal tone is to be played during the display of the
message. Five different signal tones are available for selection.
2.15.7 Signal tone for error
Options: Setting option from 1 - 5
The parameter is used to specify which signal tone is to be played during the display of the
message. Five different signal tones are available for selection.
2.15.8 Default setting for signal tone volume [%]
Options: Setting option from 10 - 100
The volume of the signal tones is preset in percent via the parameter.
