ABB IP Touch 7 - Further KNX Settings in the Device

Commissioning of the KNX Function via DCA (from ETS5)
Product manual 2CKA001473B5023
│
16
1.1.8 Further KNX settings in the device
All KNX settings for the device are made via the commissioning tool DCA, which is part of the
special ETS app (see above).
The "Smarthome mode" in the IP touch must additionally be set on KNX under menu "Technical
settings"->"Smart Home settings".
The transmission of the ETS data is made via the SD card. As soon as an SD card is available
with the KNX settings, the data can be imported in menu "Technical settings"->"Smart Home
Settings".
