Index
Product manual 2CKA001473B5023
229
8 Index
A
Access to pages ........................................... 204
Activating mute (mite timer) ........................... 207
Alarm functions - Condensate water alarm ........... 168
Alarm functions — Dew point alarm ................... 169
Alarm functions — Frost alarm temperature for HVAC
and RHCC status (°C) ........................... 154, 169
Alarm functions — Heat alarm temperature for RHCC
status (°C) ........................................ 154, 169
Application
"Door communication" ............................................ 36, 115
"Fault and alarm messages" ................................... 37, 116
"Favourite control elements" ........................................... 41
"Internal RTC" ......................................................... 40, 139
"Logical functions" .................................................. 39, 128
"Presence simulation" ............................................. 38, 125
"Scene actuator" ..................................................... 38, 121
"Time programs" ..................................................... 39, 127
Application................................................. 171
Application "Door communication"
Page protected by PIN ................................................. 115
Ring tone volume preset [%] ........................................ 115
Speech volume preset [%] ............................................ 116
Use of door communication .......................................... 115
Application "Fault and alarm messages"
Automatic archiving at an acknowledgement ............... 117
Default setting for signal tone volume [%] .................... 118
Enable export ............................................................... 117
Name of message ........................................................ 119
Page PIN-protected ...................................................... 116
Signal tone for error ...................................................... 118
Sound for alarm ............................................................ 117
Sound for Notice ........................................................... 118
Type of alarm ................................................................ 119
Type of message .......................................................... 119
Use of fault and alarm messages ................................. 116
Application "Logic functions"
Channel x - application ................................................. 128
Application "Presence simulation"
Delay time up to activation ........................................... 126
Enable export ............................................................... 126
Page protected by PIN ................................................. 125
Setting the object type .................................................. 126
Use of presence simulation .......................................... 125
Application "Scene actuator"
Name of scene ............................................................. 124
Name of scene actuator ............................................... 121
Number of participants ................................................. 121
Number of scenes ........................................................ 121
Object type x ................................................................. 122
Object x is to be changed ............................................. 124
Overwriting scenes during download ............................ 121
Scene number .............................................................. 124
Start light scene with ... ................................................ 124
Storing light scene ........................................................ 124
Telegram delay ............................................................. 121
Application "Time programs"
Overwriting time programs ............................................127
Page protected by PIN ..................................................127
Applications
Parameter .................................................................30, 46
Applications and application pages
Configuration ...................................................................36
B
Basic load active when controller is off ........ 147, 161
Basic stage cooling ....................................... 158
Basic stage cooling — Cyclic sending of the control
value (min)............................................. 159
Basic stage cooling — Hysteresis (x 0.1°C) ........... 159
Basic stage cooling — Maximum control value (0 - 255)
.......................................................... 160
Basic stage cooling — Minimum control value for basic
load (0 to 255) ........................................ 160
Basic stage cooling — Mode of thre control value ... 158
Basic stage cooling - PWM cycle cooling (min) ...... 160
Basic stage cooling — Status object cooling ......... 158
Basic stage heating ...................................... 144
Basic stage heating — Control value difference for
sending of heating control value ................... 145
Basic stage heating — Cyclic sending of the control
value (min)............................................. 145
Basic stage heating — Hysteresis (x 0.1°C)........... 145
Basic stage heating — Maximum control value (0 - 255)
.......................................................... 146
Basic stage heating — Minimum control value for basic
load (0 to 255) ........................................ 146
Basic stage heating — Mode of control value ........ 144
Basic stage heating — PWM cycle heating (min) ..... 146
Basic stage heating — Status object heating ......... 144
C
Call-up and editing of the favourites list ............. 202
Combined heating and cooling modes ................ 174
Combined heating and cooling modes —
Heating/cooling control value output ............. 175
Combined heating and cooling modes — Operating
mode after reset ...................................... 175
Combined heating and cooling modes — Switchover of
heating/cooling ....................................... 174
commissioning
via dca .............................................................................11
Commissioning
Sequence ........................................................................22
Communication objects ................................. 178
Editing .............................................................................42
Control actions of additional applications ........... 209
Control element
"Audio control" .........................................................33, 107
"Blind" ........................................................................32, 76
"Dimmer slider" .........................................................31, 64
"Dimmer" ...................................................................31, 59
To Next Page
Loading...
