ABB IP Touch 7 - Knxnet;Ip Secure

Commissioning of the KNX Function via DCA (from ETS5)
Product manual 2CKA001473B5023
│
12
Notice
■
Use a card that corresponds to the SDHC standard. Some cards may not
function correctly.
– It is recommended to use SDHC cards from ScanDisk, Kingston and
Transcend that have been fully tested and checked.
■
While pictures are being recorded or copied on the card, do not remove the
SD card nor restart the panel. Otherwise, pictures may not be displayed.
■
ABB is not liable for the performance of an SDHC card.
1.1.2 KNXnet/IP Secure
Availability of KNXnet/IP Secure
For secure IP communication, the KNX IP interface is extended by the KNXnet/IP Secure
standard. Through the optional use of KNXnet/IP Secure, all incoming and outgoing telegrams
and data are fully encrypted. By default, KNX IP Secure is always deactivated in the factory
settings of the IP touch.
Notice
■
In the ETS or DCA, the IP touch is always integrated into one of the TP lines
with the media type "TP". This happens regardless of whether KNXnet/IP
Secure is activated or deactivated in the IP touch.
–
This is due to the fact that the IP touch establishes a tunnelling
connection and the media type TP must be set for this purpose.
– KNXnet/IP Secure is always deactivated on the ETS/IP backbone.
From which firmware version KNX and KNXnet/IP Secure is available depends on the panel
used:
IP Touch 7 From version 1.70
IP touch 10 From version 2.10
