ABB IP Touch 7 - Icon Type; Status Control Element (Icon;Text) Is Operated Via a Separate Object

Control elements and application parameter
Control element "Rocker switch"
Product manual 2CKA001473B5023
│
54
2.2.4 Icon type
Options: Icons
text
The parameter is used to set whether an icon or a text is displayed.
– Icons:
Icon for left / value 1:
Options: <Selection of an icon from the list>
The selected icon is displayed when the left rocker (button) is actuated.
Icon for right / value 2:
Options: <Selection of an icon from the list>
The selected icon is displayed when the right rocker (button) is actuated.
– Text:
Text for left / value 1:
Options: <text>
The entered text is displayed when the left rocker (button) is actuated.
Text for right / value 2:
Options: <text>
The entered text is displayed when the right rocker (button) is actuated.
2.2.5 Status control element (icon/text) is operated via a separate object
Options: No
Yes
An additional 1-bit communication object "Status" is enabled via the parameter.
When the object has been enabled, the status display of the control element indicates the
current status of the object. The feedback signal object can ensure that the correct status is
always displayed.
If an actuator has a separate feedback object, this additional object can check whether the
actuator has switched. For this the feedback object of the actuator must be connected with the
feedback object of the button via a common group address (Action).
If the status display is not activated via a feedback object, the control element always changes
to the other status when actuated.
