Control elements and application parameter
"Switch" control element
Product manual 2CKA001473B5023
46
2 Control elements and application parameter
2.1 "Switch" control element
2.1.1 Name of the control element
Options: <Name>
Naming the switch control element, e.g. name of the lamp that is to be switched.
The length of the name is limited to 36 characters.
2.1.2 Function of the control element
Options: Not defined (grey)
Light (yellow)
Blind (blue)
Temperature (orange)
Scene (magenta)
Alarm (red)
Feedback (green)
The parameter is used to specify the colour of the function line.
"Light (yellow)" has been made available for functions of this type.
2.1.3 Size of the button
Options: 1 column
2 columns
The parameter is used to specify whether the control element occupies one column (one button
or control frame) or two columns (two buttons or control frames).
2.1.4 Type of switch
Options: Switchover
Press/release
Short/long
Notice
The selection depends on the type of switch.
The parameter is used to specify the signals (values) the switch sends to the KNX bus when it
is operated.
– Switchover: No additional parameters available.
– Pressing/releasing: Pressing = value 1; releasing = value 2.
The following supplementary parameters are available, see chapter 2.1.5 “Object type 1 /
value 2“ on page 48:
To Next Page
Loading...
