ABB IP Touch 7 - Page 47

Control elements and application parameter
"Switch" control element
Product manual 2CKA001473B5023
│
47
– Object type value 1: When actuated (pressing) the control element sends telegrams via
the associated communication object. This parameter is used to specify the size of the
communication object.
– Object type value 2: When actuated (releasing) the control element sends telegrams via
the associated communication object. This parameter is used to specify the size of the
communication object.
– Short/long: Short press = value 1; long press = value 2.
The following supplementary parameters are available, see chapter 2.1.5 “Object type 1 /
value 2“ on page 48:
– Long operation after...:
Options: Setting option from 0.3 - 10 seconds
The parameter is used to specify how long the button must be pressed to recognize a
long operation.
– Object type value 1: When actuated (short press) the control element sends telegrams
via the associated communication object. This parameter is used to specify the size of
the communication object.
– Object type value 2: When actuated (long press) the control element sends telegrams
via the associated communication object. This parameter is used to specify the size of
the communication object.
