ABB IP Touch 7 - Application Presence Simulation; Use of Presence Simulation; Page PIN-Protected

Control elements and application parameter
Application "Presence simulation"
Product manual 2CKA001473B5023
│
125
2.18 Application "Presence simulation"
2.18.1 Use of presence simulation
Options: Deactivated
Activated
The parameter is used to specify whether presence simulation is displayed.
– Disabled: No display in the panel. No additional parameters available.
– Activated: An entry on the application page "Time programs" is displayed for activating and
deactivating the function on the panel. The following parameters are displayed:
2.18.2 Page PIN-protected
Options: Deactivated
Activated
The parameter is used to specify whether the presence simulation application is protected by a
PIN code.
– Deactivated: The application is not protected.
– Activated: The application can only be activated or deactivated by entering a PIN code
(replay or record). The following supplementary parameter is available:
PIN code level:
Options: Level 1
Level 2
Level 3
Level 4
Level 5
The parameter is used to specify the PIN code level for the application.
Notice
Details about the PIN code, .
