Control elements and application parameter
"Switch" control element
Product manual 2CKA001473B5023
48
2.1.5 Object type 1 / value 2
Options: Inactiv
Switch
Forced operation
1-byte value [0% - 100%]
1-byte value [0 - 255]
1-byte value [-128 - 127]
Scene number
RTC operating mode
Temperature
2-byte value [-32768 - +32767]
2-byte value [0 - 65535]
2-byte floating point
4-byte value [-2147483648 - 2147483647]
4-byte value [0 - 4294967295]
14-byte text
Parameters "Object type value 1" and "Object type value 2" are used to specify the size of the
communication object.
Notice
The parameters are only available when parameter "Type of switching" is set on
"Pressing/releasing" or "Short/long".
– Inactive: No additional parameters available.
– Switch: The following supplementary parameters are available:
Sent value 1:
Options: Switchover
0
1
– Switchover: At each actuation a switchover takes place between the two set values
"Object type 1" and "Object type 2".
– 0 / 1: Switching commands are sent with 1 bit (0 or 1), e.g. for switching a switching
actuator.
Sent value 2:
Options: 0
1
– 0 / 1: Switching commands are sent with 1 bit (0 or 1), e.g. for switching a switching
actuator.
– Forced operation: Management systems can access the device directly via KNX. However,
it can also be specified that one can select manually (forced operation) via buttons. The
following supplementary parameter is available:
To Next Page
Loading...
