Control elements and application parameter
"Switch" control element
Product manual 2CKA001473B5023
49
Sent value 1 / value 2:
Options: ON, forced operation active
OFF, forced operation active
Deactivate forced operation
– 1-byte value [0% - 100%]: A value is sent as 1-byte value without a sign (percentage value).
The following supplementary parameter is available:
Sent value 1 / value 2 [0 - 100%]:
Options: Setting option from 0 - 100
– 1-byte value [0 - 255]: A value is sent as 1-byte value without a sign, e.g. an actuating value,
angle or brightness value. The following supplementary parameter is available:
Sent value 1 / value 2 [0 - 255]:
Options: Setting option from 0 - 255
– 1-byte value [-128 - 127]: A value is sent as 1-byte value with a sign, e.g. an actuating
value. The following supplementary parameter is available:
Sent value 1 / value 2 [-128 - 127]:
Options: Setting option from -128 - +127
– Scene number: The parameter is used to select a 1-byte object to link it with a scene
number. Values between 1 and 64 are available for light scene numbers. The following
supplementary parameter is available:
Transmitted value 1 / value 2 [scene number]:
Options: Setting option from 0 - 64
Calling up or storing scenes
– 0 - 64: Entry of scene number.
– Calling up or storing scenes: The parameter is used to specify whether the scene is
called up or stored (the scene number is sent with the additional information that the
scene is to be stored).
– RTC operating mode: After actuating the control element the device switches to the
parameterized operating mode. The following supplementary parameter is available:
Sent value 1 / value 2 [RTC operating mode]:
Options: Auto
Comfort
Standby
ECO
Frost/heat protection
– Temperature: After the control element is actuated, the device sends the parameterized
temperature value. The following supplementary parameter is available:
To Next Page
Loading...
