Control elements and application parameter
Application "Scene actuator"
Product manual 2CKA001473B5023
123
Value for object x:
Options: Setting option from 0 - 100
– 1-byte value [0 - 255]: A value is sent as 1-byte value without a sign, e.g. actuating value,
angle or brightness value. The following supplementary parameter is available:
Value for object x:
Options: Setting option from 0 - 255
– RGB colour: A colour value is sent as 1-byte value. The following supplementary parameter
is available:
Value for object x:
Options: Setting option from 000;000;000 - 255;255;255
The entered colour value (red, green, blue) is displayed as colour pattern next to the
parameter.
– 8-bit scene: A light scene number is sent with 8 bits. The following supplementary
parameter is available:
Value for object x:
Options: Setting option from 1 - 64
– RTC operating mode: The RTC operating mode is sent via the communication object. The
following supplementary parameter is available:
Value for object x:
Options: Comfort
Auto
Standby
ECO
Frost/heat protection
– Temperature: After the control element is actuated, the device sends the parameterized
temperature value. The following supplementary parameter is available:
Value for object x:
Options: Setting option from 16 - 31
– 14-byte text: Makes it possible to send any text with a maximum of 15 characters. The
following supplementary parameter is available:
Value for object x:
Options: <Text>
Notice
How many "Object type x" parameters are displayed depends on the setting of
the "Number of participants" parameter.
Notice
Parameter "Value for object x" can only be set for all options if parameter
"Object x is to be changed" is set on "Yes".
To Next Page
Loading...
