NoteAction
xx0800000440
Fit a lifting lug in the uppermost hole for the
attachment screws securing the base, as
shown in the figure.
6
Parts:
• A: Roundsling
• B: Lifting lug
• C: Uppermost attachment hole for
securing the base
• D: Gearbox axis 1
CAUTION
The gearbox weighs 27 kg.
All lifting accessories used must be sized
accordingly!
7
Secure the gearbox in an overhead crane or
similar.
8
See the figure in:
• Location of gearbox on page 339
Remove the attachment screws securing the
gearbox.
9
Always use guide pins in pairs!Insert guide pins in two, diagonally located,
attachment holes in the gearbox.
10
Note
Whenever parting/mating motor and gear-
box, the gears may be damaged if excessive
force is used!
11
Note
There will be some eccess oil running out
of the gearbox when it is removed. Put some
exorbant material to catch the oil.
12
Continues on next page
Product manual - IRB 2600 341
3HAC035504-001 Revision: G
© Copyright 2009-2015 ABB. All rights reserved.
4 Repair
4.8.1 Replacing gearbox axis 1
Continued
To Next Page
Loading...
