NoteAction
Art.no. is specified in Required equip-
ment on page 195.
Apply some grease in the hole for the bearings.3
Shown in the figure Cut away view of
the assembly of the tilthouse unit on
page 194.
Fit two retaining rings for bores in the hole.4
xx1000001434
Fit the outer races of the bearings - one on
each side of the retaining rings.
Note
Check that the races are turned the correct way!
See figure!
5
Parts:
A Surface for VK cover
B Outer race (close to VK cover)
C Outer race (inside retaining
rings)
D Retaining rings for bore
Shown in the figure Cut away view of
the assembly of the tilthouse unit on
page 194.
Thread the sealing ring with dustlip and the in-
ner bearing complete on the presswasher of
the pressing tool, premounting bearings.
6
Shown in the figure Press tool pre-
mounting bearing on page 196.
Art.no. is specified in Required equip-
ment on page 195.
Apply the pressing tool and press the parts to-
gether.
7
Shown in the figure Cut away view of
the assembly of the tilthouse unit on
page 194.
Apply grease on the inner diameter of the
sealing ring with dustlip.
8
Continues on next page
Product manual - IRB 760 205
3HAC039838-001 Revision: M
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.4.2 Replacing the tilthouse unit
Continued
To Next Page
Loading...
