NoteAction
xx1000001080
Refit the support washers on the outside of
the upper link arm, on the lock nuts.
9
For art. no. see:
• Required equipment on page 229
Apply locking liquid on the threads of the
lock nuts.
10
For art. no. see:
• Required equipment on page 229
Tightening torque: 120 Nm.
xx1000001080
Refit the support washer and lock nuts
complete securing the upper link arm at both
ends of the link arm. Use a KM10 socket
11
DANGER
Make sure all safety requirements are met
when performing the first test run. These
are further detailed in the section First test
run may cause injury or damage on page 26.
12
234 Product manual - IRB 760
3HAC039838-001 Revision: M
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.4.4 Replacing linkage - upper link arm
Continued
To Next Page
Loading...
