USER MANUAL | ICOS | INSTRUCTIONS | UM/ICOS-EN REV. B.2
The
Setup
menu has function tabs at the top of the screen that allows you to configure the
analyzer mode and settings. (Figure 39) These tabs will vary among analyzer types.
These tabs let you:
Manage file saving settings
Adjust the current time/date settings
Configure the Serial Output
Calibrate the analyzer to a local gas standard
Enable the laser-offset adjustment
Configure the optional Multi-Port Inlet Unit
Configure the Analog Output
Configure the optional External Dynamic Dilution System (DCS)
Service screen for technicians to check on the status of the analyzer
Use these function tabs to make adjustments to the analyzer and its’ operation.
To Next Page
Loading...
