MN1941WEN Operation 5-7
5.2.1 Starting MMC
1. On the Windows Start menu, select Programs, Mint WorkBench, Mint Machine Center.
2. In the controller pane, ensure that Host is
selected. In the information pane, click Scan.
3. When the search is complete, click once on
‘NextMove e100’ in the controller pane to
select it, then double click to open an instance
of Mint WorkBench. The NextMove e100 will
be already connected to the instance of Mint
WorkBench, ready to configure.
Go straight to section 5.4 to continue the
configuration in Mint WorkBench.
To Next Page
Loading...
Need help?
General
