ABB RER670 - DNP3 Communication Protocol

Refer to the tables in the Technical reference manual /Station communication,
specifying the information types supported by the communication protocol IEC
60870-5-103.
To support the information, corresponding functions must be included in the
protection IED.
There is no representation for the following parts:
•
Generating events for test mode
• Cause of transmission: Info no 11, Local operation
Glass or plastic fibre should be used. BFOC/2.5 is the recommended interface to
use (BFOC/2.5 is the same as ST connectors). ST connectors are used with the
optical power as specified in standard.
For more information, refer to IEC standard IEC 60870-5-103.
18.7 DNP3 Communication protocol
18.7.1 Application
GUID-EF1F0C38-9FF6-4683-8B10-AAA372D42185 v1
For more information on the application and setting guidelines for the DNP3
communication protocol refer to the DNP3 Communication protocol manual.
Section 18 1MRK 506 375-UEN A
Station communication
452 Railway application RER670 2.2 IEC
Application manual