ABB RET615 - LD0.LEDGGIO1 Indication LED States Off;Colorx

Table 29: LD0.LEDGGIO1 Indication LED states Color1/Color2
BitA RegA IEC 61850 name SA name Description Values
LD0.LEDGGIO1
3520 220.00 .LEDSt1.stVal - LED 1 state 0/1=Color1/2
3521 220.01 .LEDSt2.stVal - LED 2 state 0/1=Color1/2
3522 220.02 .LEDSt3.stVal - LED 3 state 0/1=Color1/2
3523 220.03 .LEDSt4.stVal - LED 4 state 0/1=Color1/2
3524 220.04 .LEDSt5.stVal - LED 5 state 0/1=Color1/2
3525 220.05 .LEDSt6.stVal - LED 6 state 0/1=Color1/2
3526 220.06 .LEDSt7.stVal - LED 7 state 0/1=Color1/2
3527 220.07 .LEDSt8.stVal - LED 8 state 0/1=Color1/2
3528 220.08 .LEDSt9.stVal - LED 9 state 0/1=Color1/2
3529 220.09 .LEDSt10.stVal - LED 10 state 0/1=Color1/2
3530 220.10 .LEDSt11.stVal - LED 11 state 0/1=Color1/2
3531 220.11 <reserved> 0
2.3.1.27 LD0.LEDGGIO1 Indication LED states OFF/ColorX
These LED indication points interpret the case when an indication signal is wired to
either the OK or ALARM input of the LED function block. The default color for
ALARM is red and green for OK. Colors can, however, be reconfigured with a setting
parameter.
OK
ALARM
RESET
LEDx
OK
ALARM
RESET
LEDx
Signal
Signal
GUID-775477F8-C2DE-4138-B2C0-6B7C2774D4D2 V1 EN
Figure 4: Signal wired to either OK or Alarm input
Section 2 1MRS756878 H
Modbus data mappings
26 RET615
Point List Manual