User's Manual | ACOM 700S | 1.8-54 MHz Linear Amplifier
Page 50 of 92 | S e c t i o n MENUS - SETTINGS AND OPTIONS
Table 5-1 | Transceiver interface
ICOM (Connection to the REMOTE connector)
ICOM (Connection to the RS-232 port or CT17)
KENWOOD TS-2000, 480, 590, 890, 990 and similar
YAESU FT-101, 450, 950, 991, 1200, 2000, 3000, 5000, 9000 and similar
Table 5-1 | Transceiver interface
Under CAT interface control, the amplifier follows the VFO "A" frequency changes only.
The ACOM 04AT and 06AT automatic antenna tuners follow the frequency of the
amplifier.
If your transceiver has more than one VFO, as well as in SPLIT mode, use VFO "A" for
transmission and for tuner control. If the amplifier frequency does not change over the
CAT interface, make sure you are using VFO "A" on the transceiver, as the amplifier CAT
interface only uses VFO "A" data.
To Next Page
Loading...
