6146/6156 DC Voltage/Current Generators Operation Manual
2.2.3 Menu Operation
2-25
NOTE: Only parameter items that can be set and executed in each status are displayed.
Category level Select level Input/Run level
SYS
System
(b)
I/F
Interface
BUS Interface selection
GPIB / USB / BCD
Select
GP.ADR GPIB address When GPIB is selected
0 to 30
Numeric
USBid USB.ID When USB is selected
1 to 127
Numeric
L.ONLY Addressable/Listen Only When GPIB is selected
OFF / ON
Select
6144 6144 compatible mode setting
OFF / ON
Select
Parameter type
LMT.BZ Limit detection buzzer
OFF / ON
Select
NTC.BZ Notice buzzer
OFF / ON
Select
TEST Runs the self test.
Press the [ENTER] key to run.
Run
P/KEY Runs panel/key test.
Press the [ENTER] key to run, then press each key to
confirm.
Run
P.LOCK Panel lock setting
OFF / ON
Select
PWD Panel lock release password setting
0000 to 9999
Numeric
CAL Calibration mode setting
OFF / ON
Select
CAL.DT Saves or initializes the calibration data.
SAVE/INIT
(Only displayed when CAL is ON.)
Run
QUEUE Displays the event error queue.
No. XX and error number
XX can be changed with the rotary key.
Run