ADJ WMX1 - Live Edit Editor - Value

LIVE EDIT EDITOR - FIXTURES (CON’T)
Displayed data:
• The name of the live edit to the top left.
• A grid of up to 16 xture buttons, displaying xture name and a white dot to indicate the xture has an
edit applied.
• A button to the top right to edit the values of the selected xtures.
• Three buttons to rename the live edit, set the live edit to Flash mode, and Lock the live edit which
preserves the state when changing presets (useful for Parking channels).
• The currently visible Group and Page to the bottom right.
Encoder actions:
• ● Pushing the rst encoder will reset the selected xtures, removing all live edit values from the
xtures. Moving the encoder determines whether to reset the selected xtures or all xtures. Upon
resetting the xtures, the white dots will disappear.
• ● Moving the third encoder lters the displayed xtures in the grid by group. Pushing the encoder
selects or deselects all xtures within the group.
• ● If there are more than 16 xtures within the current group. Moving the fourth encoder navigates
through between the pages of xtures.
Other actions:
• Tapping the buttons in the grid selects and deselects the xtures. When a xture is selected, the
corresponding channels will be shown on the Value screen. If 2 or more xtures of the same Fixture
Type are selected, their channels will be merged and controlled together on the Value screen.
• Tapping the rename button will show the keyboard screen allowing for the name of the live edit to be
changed.
• Tapping the Flash button will enable or disable the live edit’s Flash property. When the Flash property
is set, the Matrix button will turn white and the edit will be enabled on pressed and disabled on release.
• When editing a Live Edit, tapping the ashing Matrix button stores the new Live Edit and closes the
editor. Tapping any other button cancels the change.
LIVE EDIT EDITOR - VALUES
Displayed data:
• A grid of 16 channel buttons, each displaying the channel name and the current live edit value if one
has been set.
• The value of the selected channels is displayed to the bottom left.
Encoder actions:
• Moving the rst encoder changes the selected channel value. Tapping the encoder will show a grid of
all Features related to the selected channel.
• Pushing the second encoder will reset the selected channel, removing the live edit value from the
channel.
Other actions:
• Tapping a button in the grid selects a channel.
• Tapping the REC DMX button to the top right records the current DMX output frame and applies it to
the selected xtures.
28