ADRF SDR - System; Heartbeat Time

Advanced RF Technologies, Inc.
45
5.3.2.2 System
Figure 48 System Command
 Reboot: Clicking the reboot button will have the following popup show up:
Figure 49 Pop-up message when Reboot button is pressed
Click OK to reboot the repeater or click Cancel to exit out
 Factory Setting: Resets the repeater to the original factory settings
Figure 50 Pop-up message when Factory Setting button is pressed
5.3.2.3 Heartbeat Time
Figure 51 Heartbeat Setting
 Allows the user to enable or disable heartbeats from being sent out and also specify the time interval.