Advanced RF Technologies, Inc.
5.4.1.2 Location
This section allows the user to input the latitude and the longitude of the repeater.
Figure 57 Location Setting
5.4.1.3 Modem Box Settings
This section allows the user to specify an alternative Repeater IP, Subnet Mask, and Gateway settings. These
settings are enabled when the Host/Remote switch is set to the Remote position. When the Host/Remote switch is
changed, the repeater will reboot and will result in a temporary loss in coverage.
Figure 58 Modem Box Setting
5.4.1.4 Repeater Location Info / Repeater Installer Info
This section allows the user to specify the address of the repeater and also the information of the installer.
Figure 59 Repeater Location Info / Repeater Installer Info
To Next Page
Loading...