EKI-1526(TI) | 1528(TI) User Manual 52
6.1 Overview
EKI-1526(TI) | 1528(TI) serial device servers can be configured through a web inter-
face. By using a standard web browser, the same procedure as with the Windows
configuration utility can be used. In the browser’s address field, enter the IP Address
of your EKI-1526(TI) | 1528(TI) serial device server.s The default IP setting is
10.0.0.1, but you should use the IP which you have previously assigned for this
device. Once the IP is entered, you will be presented with the following windows.
6.2 Accessing the Web Page
6.2.1 Accessing the Web Page via Configuration Utility
To access the web page via configuration utility:
1. Select Ethernet under the desired device.
2. Click Launch Browser.
Figure 6.1 Accessing the Web Page via Configuration Utility
Note! Before using the web-based configuration, make sure your host PC
Ethernet network IP domain is as same as the serial device server, or it
can establish the TCP connection with the serial device server.
Note! It is recommended that you use Microsoft Internet Explorer 7.0 or
higher.
To Next Page
Loading...
Need help?
General
