53 EKI-1526(TI) | 1528(TI) User Manual
6.2.2 Accessing the Web Page via Web Browser
Once the device is installed and connected, power on the device. The following infor-
mation guides you through the logging in process.
1. Launch your web browser on the PC.
2. In the browser’s address bar, type the device’s default IP address (Eth1:
10.0.0.1, Eth2: 10.0.0.2).
3. The main interface displays.
6.3 System
You can change the Device Name and Device Description on this page. You can also
enable or disable the Telnet and SNMP functions. Moreover, you can set the Time-
zone related settings.
To access this page, click System.
Figure 6.2 System
The following table describes the items in the previous figure.
Item Description
Firmware version Displays the current firmware version of the device.
Revision number Displays the revision number of the device.
Device Name Enter the device name: up to 31 alphanumeric characters.
Device Description Enter the device description.
Telnet Click Enabled or Disabled to set remote access through the Telnet
Service function.
VCOM Ignore Device
ID
SNMP Click Enabled or Disabled to define the SNMP daemon.
Local Time Click Modify to set local date and time of the system.
To Next Page
Loading...
Need help?
General
