5120 1
Determines under which conditions the copy job settings are reset when the key counter is
removed. With 0, the settings are cleared if the counter is removed at the end of a job or
midway through a job. With 1, they are only cleared if the counter is removed at the end
of a job. With 2, they are not cleared at all, under either condition. With duplex copies,
the job settings are always preserved, regardless of the setting of this SP mode.
5121* Count Up Timing [0 = Feed In / 1 = Exit]
5121 1
Selects whether the key counter increments at time of paper feed-in or at time of paper
exit.
5501* PM Alarm Interval (Printout) [0 to 9999 / 0 / 0K copies/step]
5501 1 Specifies when the PM alarm occurs.
5801 Memory Clear
5801 2 Engine ( Memory Clear)
5802 Machine Free Run
5802 1
Starts a free run of both the scanner and the printer. Press "ON" to start; press "OFF" to
stop.
5803
Input Check
( Input Check (SP 5803))
5804
Output Check
( Output Check (SP 5804))
5807* Area Selection
5807 1
Selects the display language group.
1 = Japan, 2 = South America, 3 = Europe, 4 = Taiwan, 5 = Asia,
6 = China, 7 = Korea
SP 5807 1 is not cleared by SP 5801 2 ( Memory Clear).
SP Mode Tables
45
To Next Page
Loading...
