38 1100 Series DAD and MWD User Manual
3 LAN Configuration
The user may open a Telnet session using the default IP address and change
the parameters stored in the non-volatile memory of the detector. He may then
close the session, select the initialization mode “Using Stored”, power-on again
and establish the TCP/IP connection using the new parameters.
When the detector is wired to the PC directly (e.g. using a cross-over cable or a
local hub), separated from the local area network, the user may simply keep
the default parameters to establish the TCP/IP connection.
NOTE
In the “Using Default” mode, the parameters stored in the memory of the detector are not
cleared automatically. If not changed by the user, they are still available, when switching
back to the mode “Using Stored”.
To Next Page
Loading...
