Agilent Technologies 1100 Series User Manual

1100 Series DAD and MWD User Manual 49
LAN Configuration 3
5 Use the “/” and press Enter to list the current settings.
Figure 21 Telnet - Current settings in “Using Stored“ mode
6 Change the IP address (in this example 134.40.27.99) and type “/” to list
current settings.
Figure 22 Telnet - Change IP settings
information about the LAN interface
MAC address, initialization mode
TCP/IP status - here ready
active TCP/IP settings
connected to PC with controller software (e.g. Agilent
ChemStation), here not connected
Initialization mode is Using Stored
change of IP setting to
connected to PC with controller software (e.g. Agilent
ChemStation), here not connected
stored TCP/IP settings in non-volatile memory
active TCP/IP settings
Initialization mode is Using Stored

Agilent Technologies 1100 Series Specifications

General

Brand	Agilent Technologies
Model	1100 Series
Category	Laboratory Equipment
Language	English