Chapter 8 Parallelism Measurements
Positioning the Laser Head and Target Machine
8-10 Measurements Reference Guide
Figure 8-6. Positioning of optics for spindle parallelism measurements—
hollow tailstock
You are now ready to assemble, mount, and align the optics. To make a
spindle parallelism measurement, go directly to “Mounting and Aligning
Optics for Spindle Parallelism Measurements” later in this chapter. To
make a coplanar parallelism measurement, continue with the next
section, “Mounting and Aligning Optics for Coplanar Parallelism
Measurements.”
1
Reflector mounted
horizontally
2 Interferometer mounted
where tool mounts
3 Laser head placed parallel to
spindle, behind tailstock
1
2
3
To Next Page
Loading...
