Chapter 9 Flatness Measurements
Completing the Set Up Flatness Screen
Measurements Reference Guide 9-27
Figure 9-12. Set Up FLATNESS screen
3 In the Axis Lengths box, enter the lengths of perimeter lines 3 and 6 (see
Figure 9-3 or 9-4).
You can enter data into either field first. Whenever you enter data in
either box, the diagonal field goes blank. The diagonal data re-displays
when you press Enter or tab out of this field.
After you complete both fields, the software calculates the length of the
diagonal and displays it below the AG field.
To Next Page
Loading...
