Chapter 2 Linear Measurements
Mounting and Aligning the Optics on the Target Machine
2-16 Measurements Reference Guide
• Or, remove the large knurled knob from the height adjuster and screw
in the post as shown in Figure 2-9.
The method you choose to mount the optic is up to you.
Figure 2-9. Alternate height adjuster mounting
8 Mount the interferometer assembly on the spindle as shown in
Figure 2-10. Or, mount the retroreflector on the spindle as shown in
Figure 2-11.
A
Removing the large
knurled knob
B Screwing in the post
***********************
1 Spindle
2 Post
3 Height adjuster
4 Large knurled knob
2
1
3
1
0
7
8
5
A
H
E
I
G
H
T
A
D
J
U
S
T
E
R
A
4
3
AB
To Next Page
Loading...
