Installation
Setting your IP address
Released: March 2004 6850 Series II GC User Information page 246 of 256
3. When the GC finishes initializing, you will see one of the following:
If the DHCP MODE is displayed, be sure it is set to DISABLED. If not,
change the mode to DISABLED by pressing ▲ or ▼. Press LOAD to
continue to the IP ADDRESS.
4. The display will now read:
IP ADDRESS
XXX.XX.XX.XX
5. Press LOAD to adjust the IP ADDRESS values. Press ▲ or ▼ to change
values and LOAD to move from one value to the next.
6. When IP ADDRESS is completed, the display reads:
DEFAULT GATEWAY
XXX.XXX.XXX.XXX
Change the DEFAULT GATEWAY as you did the IP ADDRESS.
7. Change the SUBNET MASK value in the same manner.
8. Cycle the GC power for new settings to take effect.
To use DHCP to set the IP address
1. Turn the GC off.
2. Press and hold LOAD and turn the GC on. Continue to hold LOAD until
five dots appear in the display.
3. When the GC starts, you will see:
DHCP MODE:
DISABLED
4. Press ▲ or ▼ to change to ENABLED. Press LOAD again. The display will
now show the GC’s MAC ADDRESS. The MAC ADDRESS cannot be
altered. Record the MAC ADDRESS if needed.
5. Cycle the power to activate DHCP MODE.
DHCP MODE:
DISABLED
or
IP ADDRESS
XXX.XX.XX.XX
Lantronics card installed Card J4100A installed
To Next Page
Loading...
