Columns and Traps
Opening the oven
Released: March 2004 6850 Series II GC User Information page 21 of 256
Columns and Traps
This section describes how to install and condition columns, traps, and related
hardware in your GC in preparation for an analysis.
Opening the oven
1. If an auto injector is present, lift it off its mounting post and place it on the
bench top or on the (optional) bracket mounted on the side of the GC.
2. Press the buttons on each side of the GC just below the lid to release the
latches (Figure 4).
3. Raise the lid.
To close the lid, press down on both top front corners to compress the
insulation and engage the latches.
Figure 4. Opening the oven
To Next Page
Loading...
