Agilent Technologies 6850 Series II User Manual

Installation
Setting your IP address
Released: March 2004 6850 Series II GC User Information page 245 of 256
Setting your IP address
Each of the three LAN cards that could be installed in your 6850 GC provide
different methods of obtaining the GC’s IP address. Table 38 lists the types of
LAN cards and their available control modes.
Table 38. Available Control Modes
To determine which LAN card is installed
If you are not sure which LAN card is installed in your GC:
1. Turn the GC off.
2. Press and hold LOAD and turn the GC on. Continue to hold LOAD until
five dots appear in the display.
3. When the GC finishes initializing, you will see one of the following:
If the GC does not display either of these two screens, your GC uses card
J2552B or card J4100A and firmware that does not support local IP
addressing. If this is the case, BootP must be used to obtain the IP address.
To set the IP address locally
Caution Be sure the IP address you enter is correct and is not in use by another device
(such as a printer).
1. Turn the GC off.
2. Press and hold LOAD and turn the GC on. Continue to hold LOAD until
five dots appear in the display.
LAN card Control modes GC firmware
J2552B
BootP
a
a Refer to your Cerity Chemical or ChemStation software CD for a copy of BootP server software
A.03.XX or greater
J4100A
b
b Local addressing requires LAN card firmware revision K.08.04 or greater
BootP
a
, GC front panel A.03.XX or greater
Lantronics DHCP, GC front panel, Control Module A.03.XX or greater
DHCP MODE:
DISABLED
or
IP ADDRESS
XXX.XX.XX.XX
Lantronics card installed Card J4100A installed

Agilent Technologies 6850 Series II Specifications

General

Brand	Agilent Technologies
Model	6850 Series II
Category	Laboratory Equipment
Language	English