44 Operation Manual
3 Operating in Electron Impact (EI) Mode
Operating the MS from the Data System
Operating the MS from the Data System
The Agilent MassHunter Data Acquisition Workstation
automates tasks such as pumping down, removing the ion
source, monitoring settings, setting temperatures, tuning, and
venting the MS. These tasks are described in this chapter.
Additional information is described in the manuals and online
help supplied with the MassHunter Workstation software.
Your 7200 Q-TOF GC/MS is available in two configurations. The
7200 Q-TOF GC/MS EI RIS Bundle (G3850AA) operates in EI
mode with the high sensitivity extractor EI removable ion
source (RIS). The 7200 Q-TOF GC/MS EI/CI RIS Bundle
(G3851AA) provides the capability of operating in either EI or
CI modes, using the new RIS technology. You must specify the
type of ionization you are using in the Acquisition software tune
file used by your method.
CAUTION
The software and firmware are revised periodically. If the steps in
these procedures do not match your MassHunter Workstation
software, refer to the manuals and online help supplied with the
software for more information.
To Next Page
Loading...
