Introduction 1
Intended Use
Operation Manual 23
Intended Use
Agilent products must only be used in the manner described in
the Agilent product user guides. Any other use may result in
damage to the product or personal injury. Agilent is not
responsible for any damages caused, in whole or in part, by
improper use of the products, unauthorized alterations,
adjustments or modifications to the products, failure to comply
with procedures in Agilent product user guides, or use of the
products in violation of applicable laws, rules or regulations.
Cleaning/Recycling the Product
To clean the unit, disconnect the power and wipe down with a
damp, lint-free cloth. For recycling, contact your local Agilent
sales office.
Liquid Spills
Do not spill liquids on the MS.
Moving or Storing the MS
The best way to keep your MS functioning properly is to keep it
pumped down and hot, with carrier gas flow. If you plan to
move or store your MS, a few additional precautions are
required. The MS must remain upright at all times; this requires
special caution when moving. The MS should not be left vented
to atmosphere for long periods. For more information, see “To
Move or Store the MS” in the Agilent 7200 Q-TOF GC/MS
Troubleshooting and Maintenance Manual.
To Next Page
Loading...
Need help?
General
