52 Agilent 8453 Dissolution Testing System Installing and Operating Manual
2Setting Up
Installing a Valve-based Sampling System
Part Numbers
See Table 7 on page 23 for details of fittings.
Tab le 14 Ordering Information for Replacement Parts and Tubing Kits
*
* For part numbers of cell fittings and ferrules, tubing fittings, ferrules, conical adapters and unions,
see the UV-visible section of Agilent’s Accessories and Supplies for UV-visible Spectroscopy Cata-
log.
Description Part Number
Peristaltic pump 1VS, 230 V G1103-60004
Peristaltic pump 1VS, 115 V G1103-60006
Valve/Pump controller, 115 V 89078-60001
Valve/Pump controller, 230 V 89078-60002
Valve drive, 50Hz 89079-60002
Valve drive, 60Hz 89079-60003
Valve head 5063-6575
Valve rotor seal 5067-1539
Controller-GPIO cable G1103-61610
Controller-valve cable 5062-2407
Controller-pump cable G1103-61612
Filter tips (pack of 1000) 5181-1246
Flow cell, 1 mm path length 5063-6570
Valve system tubing kit
†
† Supplied with pre assembled tubing and fittings.
5042-1331
Peristaltic pump tubing, 2.06 mm inner diameter (12) 5041-2166
Dissolution probe kit
‡
‡ Supplied pre assembled.
5042-1332
Teflon tubing kit, 0.8 mm inner diameter, 1.6 mm outer diameter (10 m) 5041-2191