28
S:\Hp8960\Generic Documents\Manual Operation Getting Started Guide\Pi_manual operation getting started guide\chapters\is136_gen_op_overview_cell_parms.fm
How Do I Change Cell Parameters?
How Do I Change Cell Parameters?
Cell parameters specify the information sent to the mobile to identify the cell and to
tell the mobile to report mobile assisted handoff (MAHO) information.
1. Press the
CALL SETUP key.
2. Press the Operating Mode (
F1) key and select Active Cell operating mode.
3. Press the
More key to select screen 2 of 2.
4. Press
F1, F2, or F3 to change available cell parameters: digital control channel uses
System ID, SOC, and MCC. Analog Control Channel uses System ID.
5. Press the MAHO Info (F6) key to access MAHO BER and RSSI features (only
available during digital traffic channel (DTC) operation).
3
1
4
5
To Next Page
Loading...
Need help?
General
