cdma2000 Measurement Procedures
69
S:\Hp8960\Generic Documents\Manual Operation Getting Started Guide\Pi_manual operation getting started
cdma2000 Measurement Procedures
The following step-by-step procedures explain how to manually perform specific
measurements available on the cdma2000 Test Application. A detailed description of
each measurement is given in the Reference information on the documentation
CD-ROM and at the Agilent 8960 support website
(http://www.agilent.com/find/8960support/).
Setup parameters for each measurement are assumed to be set to their default (full
preset) values unless otherwise stated.
NOTE To obtain measurement results a call must first be connected See “A.
Establish a call.” on page 48
The following measurement procedures are provided:
• “Measuring Waveform Quality” on page 70
• “Measuring Handoff Waveform Quality”
• “Measuring Digital Average Power” on page 72
• “Measuring Channel Power” on page 73
• “Measuring Access Probe Power” on page 74
• “Measuring Frame Error Rate (FER)” on page 76
• “Measuring Code Domain Power and Code Domain Power + Noise” on page 79
• “Measuring Code Channel Time/Phase Error” on page 82
• “Measuring Gated Power” on page 83
• “Measuring TX Spurious Emissions” on page 84
To Next Page
Loading...
Need help?
General
