37
S:\Hp8960\Generic Documents\Manual Operation Getting Started Guide\Pi_manual operation getting started
AMPS/136 Mobile Measurements
Measuring Digital Transmit Power
This measurement can only be performed with the mobile on a digital traffic channel.
1. Establish a call with the mobile on a digital traffic channel.
2. Press the Measurement selection key.
3. Select the Digital Transmit Power measurement.
4. Press the Digital Transmit Power Setup (
F1) key.
5. Set the measurement parameters as needed for your measurement situation.
To see the effects of sending a change power level command to the mobile, press Dig
MS TX Level (
F9) and slowly change the setting while observing the Digital Transmit
Power display.
Observe how sending a change power
level command causes the mobile’s
output level to change.
To Next Page
Loading...
