94
S:\Hp8960\Generic Documents\Manual Operation Getting Started Guide\Pi_manual operation getting started guide\chapters\GPRS_gen_op_overview_cell_parms.fm
How Do I Change Cell Parameters?
How Do I Change Cell Parameters?
NOTE You can only change two cell parameters - 3 Digit MNC for PCS1900
and Guard Period Length. Other cell parameters such as MCC, MNC,
and LAC are fixed. To change the 3 digit MNC for PCS1900 the cell
must be set to off by pressing the
CALL SETUP key, then Operating
Mode (
F1), and then selecting Cell Off.
A. Select the Cell Parameters menu.
1. Press the CALL SETUP key.
2. Press the Cell Info (
F6) key.
3. Press the Cell Parameters (
F2) key.
1
3
To Next Page
Loading...
