44
S:\Hp8960\Generic Documents\Manual Operation Getting Started Guide\Pi_manual operation getting started guide\chapters\is136_man_measurements.fm
AMPS/136 Mobile Measurements
Measuring Frequency Stability
This measurement can only be performed with the mobile on an analog voice channel
(AVC).
1. Establish a call with the mobile on an analog voice channel.
2. Press the
Measurement selection key.
3. Select the Frequency Stability measurement.
4. Press the Frequency Stability Setup (
F1) key.
5. Set the measurement parameters as needed for your measurement situation.
A typical frequency stability measurement result is shown above.
To Next Page
Loading...
