48
S:\Hp8960\Generic Documents\Manual Operation Getting Started Guide\Pi_manual operation getting started guide\chapters\cdma2000_gen_op_overview_make_meas.fm
How Do I Make Measurements on a Mobile Station?
How Do I Make Measurements on a Mobile Station?
A. Establish a call.
1. Connect the mobile station to the Test Set.
2. Make a call (see “How Do I Set Up a Call?” on page 52).
B. Select measurements.
1. Press the Measurement selection key.
2. Highlight a measurement and press the knob.
3. Repeat steps 1 and 2 to select additional measurements.
For a complete list of measurement procedures, see “cdma2000 Measurement
Procedures” on page 69
2
1
The gray boxes indicate
that the measurement is
being made, but the results
are not being displayed.
These black boxes indicate
that access probe power
measurement results are
being displayed in the lower
measurement window, and
channel power results are
being displayed in the upper
measurement window.
To Next Page
Loading...
