103
Agilent InfiniiVision 3000 X-Series Oscilloscopes
User's Guide
s1
6
Digital Channels
To connect the digital probes to the device under test 103
Acquiring waveforms using the digital channels 107
To display digital channels using AutoScale 107
Interpreting the digital waveform display 108
To switch all digital channels on or off 110
To switch groups of channels on or off 110
To switch a single channel on or off 110
To change the displayed size of the digital channels 109
To reposition a digital channel 111
To change the logic threshold for digital channels 110
To display digital channels as a bus 112
Digital channel signal fidelity: Probe impedance and grounding 115
To replace digital probe leads 120
This chapter describes how to use the digital channels of a Mixed- Signal
Oscilloscope (MSO).
The digital channels are enabled on MSOX3000 X- Series models and
DSOX3000 X- Series models that have the DSOX3MSO upgrade license
installed.
To connect the digital probes to the device under test
1 If necessary, turn off the power supply to the device under test.
To Next Page
Loading...
Need help?
General
