350 Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
22 CAN/LIN Triggering and Serial Decode
Searching for LIN Data in the Lister
The oscilloscope's search capability lets you search for (and mark) certain
types of LIN data in the Lister. You can use the [Navigate] key and
controls to navigate through the marked rows.
1 With LIN selected as the serial decode mode, press [Search].
2 In the Search Menu, press the Search softkey; then, turn the Entry knob
to select the serial slot (Serial 1 or Serial 2) on which the LIN signal is
being decoded.
3 Press Search; then, select from these options:
• ID — Finds frames with the specified ID. Press the Frame ID softkey
to select the ID.
• ID & Data — Finds frames with the specified ID and data. Press the
Frame ID softkey to select the ID. Press the Bits softkey to enter the
data value.
• Errors — Finds all errors.
For more information on searching data, see "Searching Lister Data" on
page 126.
For more information on using the [Navigate] key and controls, see
"Navigating the Time Base" on page 58.