283
Agilent InfiniiVision 3000 X-Series Oscilloscopes
User's Guide
s1
19
Utility Settings
I/O Interface Settings 283
Setting up the Oscilloscope's LAN Connection 284
File Explorer 287
Setting Oscilloscope Preferences 289
Setting the Oscilloscope's Clock 292
Setting the Rear Panel TRIG OUT Source 292
Performing Service Tasks 293
Configuring the [Quick Action] Key 298
This chapter explains oscilloscope utility functions.
I/O Interface Settings
The oscilloscope can be accessed and/or controlled remotely via these I/O
interfaces:
• USB device port on the rear panel (square shaped USB port).
• LAN interface when a LAN/VGA module is installed in the rear panel
module slot.
• GPIB interface when a GPIB module is installed in the rear panel
module slot.
To configure the I/O interfaces:
1 On the oscilloscope's front panel, press [Utility].
2 In the Utility Menu, press I/O.
3 In the I/O Menu, press Configure.