Save/Recall (Setups, Screens, Data) 17
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide 275
1 Press [Save/Recall] > Recall > Recall:; then, turn the Entry knob to select
Mask (*.msk).
2 Press the softkey in the second position and use the Entry knob to
navigate to the file to recall. See "To navigate storage locations" on
page 272.
3 Press the Press to Recall softkey.
A message indicating whether the recall was successful is displayed.
4 If you would like to clear the display or clear the recalled mask, press
Clear Display or Clear Mask.
To recall reference waveform files from a USB storage device
1 Press the [Save/Recall] key.
2 In the Save/Recall Menu, press the Recall softkey.
3 In the Recall Menu, press the Recall softkey and turn the Entry knob to
select Reference Waveform data (*.h5) .
4 Press the To Ref: softkey and turn the Entry knob to select the desired
reference waveform location.
5 Press the softkey in the second position and use the Entry knob to
navigate to the file to recall. See "To navigate storage locations" on
page 272.
6 Press the Press to Recall softkey.
A message indicating whether the recall was successful is displayed.
7 If you would like to clear the display of everything except the reference
waveform, press Clear Display.
To recall arbitrary waveforms
Arbitrary waveform files can be recalled from one of four internal (\
Agilent Flash) locations or from an external USB storage device.
When recalling arbitrary waveforms (from an external USB storage device)
that were not saved from the oscilloscope, be aware that:
• If the file contains two columns, the second column is automatically
chosen.
To Next Page
Loading...
Need help?
General
