276 Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
17 Save/Recall (Setups, Screens, Data)
• If the file contains more than two columns, you are prompted to select
which column to load. Up to five columns are parsed by the
oscilloscope; columns above the fifth are ignored.
• The oscilloscope uses a maximum of 8192 points for an arbitrary
waveform. For more efficient recalls, make sure your arbitrary
waveforms are 8192 points or less.
To recall an arbitrary waveform:
1 Press [Save/Recall] > Recall > Recall:; then, turn the Entry knob to select
Arbitrary Waveform data (*.csv).
2 Press the softkey in the second position and use the Entry knob to
navigate to the file to recall. See "To navigate storage locations" on
page 272.
3 Press the Press to Recall softkey.
A message indicating whether the recall was successful is displayed.
4 If you would like to clear the display, press Clear Display.
See Also • "To edit arbitrary waveforms" on page 255
Recalling Default Setups
1 Press the [Save/Recall] key.
2 In the Save/Recall Menu, press Default/Erase.
3 In the Default Menu, press one of these softkeys:
• Default Setup— recalls the oscilloscope's default setup. This is the same
as pressing the front panel [Default Setup] key. See "Recall the Default
Oscilloscope Setup" on page 29.
Some user settings are not changed when recalling the default setup.
• Factory Default— recalls the oscilloscope's factory default settings.
You must confirm the recall because there are no user settings that
are left unchanged.
To Next Page
Loading...
Need help?
General
