EasyManuals Logo

Agilent Technologies InfiniiVision 3000 MSO-X 3012A User Manual

Agilent Technologies InfiniiVision 3000 MSO-X 3012A
424 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #284 background imageLoading...
Page #284 background image
284 Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
19 Utility Settings
LAN — When a DSOXLAN LAN/VGA module is installed, you can use
the LAN Settings and LAN Reset softkeys to configure the LAN
interface. See "Setting up the Oscilloscope's LAN Connection" on
page 284.
GPIB When a DSOXGPIB GPIB module is installed, you can use the
Address softkey to configure the GPIB address.
There are no configuration settings for the USB interface.
When an I/O interface is installed, remote control over that interface is
always enabled. Also, the oscilloscope can be controlled via multiple I/O
interfaces (for example, USB and LAN) at the same time.
See Also Chapter 20, “Web Interface,” starting on page 301 (when the
oscilloscope is connected to a LAN).
"Remote Programming via the Web Interface" on page 306
The oscilloscope's Programmer's Guide.
"Remote Programming with Agilent IO Libraries" on page 307
Setting up the Oscilloscope's LAN Connection
When the DSOXLAN LAN/VGA module is installed, you can place the
oscilloscope on the network and set up its LAN connection. Once that is
done, you can use the oscilloscope's web interface or remotely control the
oscilloscope via the LAN interface.
The oscilloscope supports methods for automated LAN configuration or
manual LAN configuration (see "To establish a LAN connection" on
page 285). It is also possible to set up a point- to- point LAN connection
between a PC and the oscilloscope (see "Stand- alone (Point-to- Point)
Connection to a PC" on page 286).
Once the oscilloscope is set up on the network, you can use the
oscilloscope's web page to view or change its network configuration and
access additional settings (like the network password). See Chapter 20,
“Web Interface,” starting on page 301.
NOTE
When you connect the oscilloscope to a LAN it is a good practice to limit access to the
oscilloscope by setting a password. By default, the oscilloscope is not password protected.
See "Setting a Password" on page 312 to set a password.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Agilent Technologies InfiniiVision 3000 MSO-X 3012A and is the answer not in the manual?

Agilent Technologies InfiniiVision 3000 MSO-X 3012A Specifications

General IconGeneral
BrandAgilent Technologies
ModelInfiniiVision 3000 MSO-X 3012A
CategoryTest Equipment
LanguageEnglish

Related product manuals